Driveway and walkway coatings

Driveway coatings are a smaller part of what we do than garages, and we're straightforward about why: the failure risk is higher. A driveway sees direct UV all day, surface temperatures that swing enormously between afternoon and night, hot tyres parked directly on it, and in some cases tree root movement underneath. Not every driveway is a good candidate.

When it works well

• Sound, relatively young concrete with no active cracking
• Adequate drainage — water shouldn't pond anywhere
• An owner who wants decorative concrete rather than a plain slab
• Realistic expectations about maintenance and recoat intervals

When we'd say no

• Active settlement cracking or heaving
• Significant spalling across a large area — replacement is often better value
• A slab that ponds water after rain

Why exterior work carries more risk

We are more cautious about driveways than any other surface we coat, and it is worth explaining why rather than just quoting higher.

• Full UV, all day. A garage floor sees sunlight for a few feet inside the door. A driveway sees it across its entire area, every day.
• Maximum thermal cycling. Surface temperatures swing 60°F or more daily in summer. Every cycle works the bond.
• Hot tyres, parked directly. Same mechanism as garage hot tire pickup, but with the slab already at 140°F rather than 85°F.
• Subgrade movement. Driveways sit on fill that settles, and tree roots are a real factor in older neighbourhoods.
• Water. Nowhere for it to go but across the surface, concentrating at low points.

None of this makes a driveway coating a bad idea. It makes candidate selection matter far more than it does indoors.

What we assess before quoting a driveway

1. Crack survey. Any crack with vertical displacement or progressive widening is disqualifying until the cause is addressed.
2. Drainage. We look at it after rain if we can, or run a hose. Ponding is a problem.
3. Surface soundness. Widespread spalling means the top of the slab has failed, and coating over failed concrete relocates the problem rather than solving it.
4. Slab thickness and reinforcement. Where we can determine it. A thin unreinforced driveway will keep cracking regardless of what goes on top.
5. Trees. Root proximity is the most common cause of driveway movement in older Henderson neighbourhoods.

Realistic expectations

An exterior coating on a sound slab with an aliphatic topcoat should give you seven to twelve years before it wants a recoat. That is genuinely shorter than an interior garage floor, and any contractor telling you otherwise is either inexperienced or optimistic.

The recoat itself is straightforward — clean, light abrade, new topcoat — and costs a fraction of the original. Planning for it as scheduled maintenance rather than treating it as failure is the right frame.

Alternatives worth considering

If your driveway is in poor condition, a coating may not be the best value. Two alternatives we will happily point you toward even though we do not do them: a polymer overlay or micro-topping adds genuine thickness and can correct minor surface deficiency, and replacement, while expensive, resets the clock entirely on a slab that is at the end of its life. We would rather say that than coat something that will disappoint you.

Common questions